HDPE geomembranes produced by different manufacturers have different linear expansion coefficients

      Since the impermeable membrane has obvious thermal expansion and contraction properties and heat absorption, the temperature of the uncovered impermeable membrane surface can reach 60-70°C under the condition of 30°C. The construction period of this project is in high temperature weather. According to the on-site temperature measurement, the average maximum temperature in summer can reach about 39℃. Therefore, the shrinkage of the impermeable membrane used in the project should be considered when cutting the membrane. According to construction experience, HDPE geomembranes produced by different manufacturers have different linear expansion coefficients. The calculation should be based on the data provided by the manufacturer. In a high temperature environment, the film should be cut according to the calculated length of the impermeable film.

    After laying the impermeable membrane in place, pay attention to protecting the installed impermeable membrane when adjusting the position; the overlap width of the seam should meet the specification requirements (hot melt welding is 100±20mm; extrusion welding is 75±20mm) ; When laying, a considerable amount of expansion and contraction should be reserved according to the changes in temperature, site topography and performance requirements of the mold. The direction and position of the joints and laps should be reasonable to reduce the stress on the joints and avoid the places where the stress is concentrated. .

1628652365(1) (1)

You Might Also Like

Send Inquiry